wireless
04-30-2021, 05:34 AM
I have PureFibre with my own router plugged directly into nokia ont. this works fantastic with ipv4, 0 issues! until I enable ipv6 in my router. It's able to get the ipv6 no problem and it works for a while but 30-60 minutes later my connection goes red. I need to reboot the nokia or disable ipv6 in my router.
I have tried this with 2 of my routers both ASUS an AX11000 and XT8 . I have tried with multiple versions of the firmware, all with exact same results
If I use the Telus Router ipv6 works fine, if I connect my router in bridge mode exact same result. but if I connect my router in non bridge mode ipv6 works as expected (but double nat) and of course I do not want to use their router just so I get ipv6.
Connection Type: Native
DHCP-PD: Enabled
Auto Config Settings: Stateless
Connect to DNS Server Auto: Enabled
Enable Router Advertisement: Enabled
Any one have some thoughts?
More... (https://forum.telus.com/t5/Internet-Home-Phone/PureFibre-ipv6-own-router-issues/m-p/118293#M29137)
I have tried this with 2 of my routers both ASUS an AX11000 and XT8 . I have tried with multiple versions of the firmware, all with exact same results
If I use the Telus Router ipv6 works fine, if I connect my router in bridge mode exact same result. but if I connect my router in non bridge mode ipv6 works as expected (but double nat) and of course I do not want to use their router just so I get ipv6.
Connection Type: Native
DHCP-PD: Enabled
Auto Config Settings: Stateless
Connect to DNS Server Auto: Enabled
Enable Router Advertisement: Enabled
Any one have some thoughts?
More... (https://forum.telus.com/t5/Internet-Home-Phone/PureFibre-ipv6-own-router-issues/m-p/118293#M29137)