I'm trying to set up IPv6 connection on an T3200M but I'm only getting "No network access" error. I'm not sure where else to start to get this fixed (called and they said they didn't know either).
Also using a D-Link DGS-105 switch and an Alcatel-Lucent modem (at least I think it is).
The following settings were followed:
IPv6 WAN Settings
IPv6: Dnabled
WAN IPv6 IP Protocol: DHCPv6
Request PD Only: Yes
IPv6 DNS Type: Default Servers
IPv6 LAN Settings:
LAN Connection Type: stateless
ULA Support: disable
Subnet Number: 0
Delegated to LAN: No
More...