NH20A Bridge Mode and admin page not find

[wireless]

Hi @DrPacman,
Telus technician gave me the NH20A today and installed it successfully. Now the path is:
PurFibre ==> Nokia SFP+ ==> NH20A (10G bridge mode) ==> RJ45 10G port ==> CAT8 ==> UDM-SE (RJ45 WAN port 2.5G supported) ==> Switch ==> My PC.

My PC gets full speed and works well. Thank you for your previous suggestions. I have some more questions here and hope you can help me out again:

1. The NH20A has four bridge modes and the Technician could not answer the difference between bridge modes. I cannot remember their name, but I pick the 10G Bridge mode in this case. Am I correct?
   1. 10G Bridge Mode.
   2. Full Bridge Mode.
   3. XXXX Bridge Mode (cannot remember).
   4. XXXX Bridge mode (cannot remember).
2. After I set the NH20A to 10G Bridge mode, I cannot access this NH20A device anymore. I tried 192.168.1.254 and 192.168.1.1 with different ports. The technician told me to reset the NH20A to access the admin page again. So the device admin page won't allow anyone to access its admin page after it is set to Bridge mode. Am I correct?
3. Since the RJ45 works fine, should I get the MikroTik S+RJ10? Will this SFP+ work better compared with RJ45?
   1. NH20A 10G port ==> CAT8 ==> MikroTik S+RJ10 ==> UDM-SE SFP+ 10G port
4. Should I try the 10G SFP+ (Amazon Link) to replace the NH20A and the Nokia SFP+? The Telus technician said he don't know and I can try.

More...